Spas (henceforth referred to as “bubbles”) are an oasis of relaxation and rejuvenation. The most common questions asked by new owners, though, concern how to drain a spa – or if they need to be drained at all. The answer is that it depends on the type of bubbles you’ve got (a few different kinds exist), whether you use them often, and how clean the water is kept. We suggest visiting laser hair removal in Manhattan.
Steps to drain a spa
There are a number of methods you can use to drain your spa:
– Using the drain hole at the bottom of the bubbles.
– A special hose with a vacuum connector.
– Plugging it and moving it off its base (the best method if you won’t be using the bubbles for a while).
– Using a siphon pump that will also clean the water for you.
Use a standard garden hose to drain your spa, or connect a special drain hose in tandem with a vacuum nozzle if you need help evacuating all of the water in your spa. If possible, move your spa off its base when draining it. If this is not an option, you can use a siphon pump to suck out the water and even add an anti-freeze solution to prevent any further problems. Visit the wax centers in midtown Manhattan to get the best care for waxing.
A vacuum hose sucks the water from the bubbles into a nearby sink or drains if your bubbles don’t have one already built-in. A garden hose hooked up to a spigot works if you’ve got the time to take it slow; this will also help keep any remaining water off your lawn.
When emptying bubbles, be sure to lay down a tarp or plastic sheeting under the spa. This will prevent any remaining water from damaging surfaces or even spilling into your home.
Any of these methods will also help you remove standing water that will eventually grow algae. If your bubbles are left to sit for a long time, be sure to use a solution with algaecide mixed in before re-filling the spa.
Steps to re-fill the spa
Be sure to thoroughly clean, dry, and disinfect your bubbles before re-filling them.
Fill the bubbles with water as soon as possible since standing water is a breeding ground for algae and other contaminants. Try to avoid adding a new bubble solution right before filling them back up – it will mix with the remaining bubble potion from your last batch. Using an old bowl or container, remove a small portion of the existing/remaining bubble solution (~5%) to make room for the fresh bubble potion. Make sure your solution is at room temperature, and slowly mix it in a while, adding a new solution.
If you are using a chlorine-based algaecide, add that before filling up the bubbles with water. If you are using bromine or another non-chlorine chemical, mix it with a small amount of bubble solution before adding it to the bubbles.
You can also add bromine sticks, super shock (bleach), and other chemicals while bubbles are filling. Keep in mind that you should always add any chemicals before completely re-filling your spa – otherwise, they may lose effectiveness over time.